So something odd happed today when I signed into to play. First my setup, I'm running an all Virpil setup. MT-50CM2 stick, CM2 Throttle, VPC Rudder Pedals and two of their Control Boxs. I had all of these setup and working well. When I signed in tonight, I tried to take off but the stick wasn't controlling pitch or roll as they had previously been setup to handle. I would have suspected something wrong with the stick or a connection but I had just been playing MS Flight Sim and it was fine. I jumped into the controller keybinds and went in to check and I could see Input4 (the name assigned to the flight stick) was set to control pitch and roll as it had been. I decided to remap them just to check and that's when I noticed something odd. Moving the stick registered with SC but it came back as input6 now and while it had been labeled "X-Axis (Input4)", it was now labeled, "X (Input6). I jumped back into AC and the ship moved but both the axis needed to be inverted. I tried to go into the Inversion settings but it won't allow me to select Input6. So at the moment I'm dead in the water and to be honest, I'm not sure what changed. I didn't see any change from yesterday when I played in MS Flight Sim or as it did last time I played Elite Dangerous. I tried to delete my USER folder and no luck, same issue. Does anyone know how SC decides what Input a controller as mapped as for me to see what might have changed and if I can reset it from 6 back to Input4?