After hundreds of hours and even more hundreds of dollars, my project is finally complete! There's some issues that could be fixed, but for now I don't have the will to deal with them: The left slider is so inconsistent that it is basically useless. The right slider is clearly a logarithmic and not a linear pot as was advertised. (It is currently sitting at about the 200 value, the rest of the way up it goes to 1000.) The bottom right two switches were either defective and I didn't notice, or I melted the internals when I soldered them. Either way, the "down" position shorts when the switches move at all. The Scan button in the bottom left seems to short to the other five pins in its "column." This was probably a mistake I made when soldering the pcb. The "backlight" LEDs are all placed on one part of the pcb, evidenced by the hotspot in the bottom left corner of the Drake logo. If I ever do a version 2, backlighting needs a serious revisit since the board isn't as big as the front panel so not even spreading them across the board will give a proper backlight effect. The far left covered switch and the second from the right weren't intended to be covered. Actually, when we cnc'd the front panel holes we didn't offset the bit properly, so it centered the bit on the cut lines. This made all the holes slightly larger than intended and the round buttons would fall through. So, I scavenged parts from the two covered switches I had left over to act as washers for the buttons. I was still short by two, so I Dremeled to fit some plastic washers I had in my junk hardware bin. The silver buttons are latching, while the black ones are momentary. I intended the latching switches to work with keybinds marked as "toggle/hold" like Lights. They have an LED ring when they are depressed so it gives a nice indication that, for example, the lights are on. I am certain I had verified in 3.12 that this behavior worked with Cruise and Decouple as well even though they are only marked as "toggle" but now in 3.13 it does not work that way. Curses! Lessons learned: Cheap buttons and switches work well enough, but potentiometers need to be quality or they just aren't worth it. If you get buttons/switches with a consistent height you can sandwich them between the front panel and pcb and safe yourself wiring headaches! Building myself was a lot of fun and a ton of learning (this is my first electronics project since doing a merit badge two decades ago, and my first time soldering besides a couple of through-holes at the hackers corner of an OpenWest conference), and it is fun to have the exact blend of controls I wanted, but it would have been cheaper to buy a professional product like something from https://www.black-hog.com/ If anyone is interested I can share the files and parts list if you want a leg up in building your own. Some more pics of the process: Sadly, the old Razer Orbweaver in the last pic is picked up by the system as a joystick, which makes four in the setup. SC crashes on load when I try to use four controllers, but works fine with three. I guess I'm stuck with my full keyboard for now. :disappointed: Finally, a short video of my favorite feature: