I recently received a pair of Virpil Alphas and during the initial calibration I noticed something strange. I would appreciate if someone with virpil alpha constellation R+L can check his physical button layout to compare behaviors in order to know if my left stick is working as intended or , I hope not, it has been assembled in a weird way. Maybe I did something wrong during configuration. ?? The point is that I think that both sticks should be a mirror of each other, so red button should be "physical button 12" on both sticks... but for some reason it is showing as button 6 in my left hand. Then, black button (6 on Right) is listed as 12 in left hand. So basically both buttons are swapped. Same goes for both 5 ways next to that buttons (7,8,9,10,11 and 13,14,15,16,17 if I remember well) Also scroll wheel up and down, as well as both push stages of the wheel are inverted in the left. (21, 22, 23, 24). So, it's like the internals of this whole section where mounted upside down to say so... I also noticed that brake lever rests in 0% in the right stick while left sticks shows 100% All else buttons are mapped matching same numbers for same locations for both hands . The analog thumb stick press, the 5 way on the thumb rest, the 3 way in index, pinky, lever as button, both triggers and so on, all seem to match the other hand as one could expect. I know I could invert the lever and remap the physicals in the left hand to match the logicals in the right hand an make things simplier,...but I would like to know if that is normal in all Alpha-L grips and the reason behind. P. S. Firmware is updated and both hands profiles were created checking the right or left box as convenience. Thanks in advance.