Hi all, Just wanted to share a little mod I did to my Virpil v3 throttle and some VR Insight flight panels. These are actually rubber thread protector caps to add a little extra grip and a bit of color; I thought the red looked good on the throttle toggles, and went with blue on the panels because the buttons have blue LEDs. The process is pretty simple; just got some caps from eBay (the seller's info is below), trimmed them down with an Exacto, and pushed them over the metal toggles. The 3/16th ones worked well with "normal" full-sized switches (like Virpil or Warthog), but the four small ones on the left VR Insight panel are REALLY tiny (which started me thinking about this in the first place) and are actually doubled up; 1/16th first, then 1/8th caps over those. Here's a couple of extra tricks if you want to do something similar; - These things need to be snug, and will actually seal in an air bubble that will keep them from going on all the way. I used a straight pin to poke a single hole in the top of each one, and that will let the air out. - If needed, you can Q-tip a TINY bit of Vaseline in the caps to make them easier to get on too, but not much because you don't want them sliding back off on their own (you can always slit them with a razor to get them off again). - Measure and cut them off short enough to clear the actual panel/base plates, at least a MM or so. Most of these metal toggles are spring-loaded and will compress a few MM's when you're trying to get the caps on, so they will bottom out before the caps are all the way down/on, and once installed they may contact the panel and interfere with that nice audible click. (keep a blade handy, you can also trim them a bit when they'r already on, you won't hurt the metal toggle any). Have fun! Here's the seller I got my caps from: "pillars-of-autumn-engraving" (100% not affiliated, but they were cheap and very fast.) And a link (several colors to choose from): https://www.ebay.com/itm/vacuum-caps-round-rubber-vinyl-dust-caps-thread-protector-pipe-cover-paint-mask/283133961703?hash=item41ec1965e7:m:mZXeZOzg75uS1fFE8U57FjA