Link to original thread - https://forums.robertsspaceindustries.com/discussion/350398/helm-simpit/p1 October 2016 And then there were two ! Thanks to Okona & Krel ! http://www.dualsticks.com/ https://robertsspaceindustries.com/spectrum/community/SC/forum/50174/thread/left-hand-warthog-grips https://robertsspaceindustries.com/spectrum/community/SC/forum/50264/thread/dual-warthog-mount-design-build-thread 04/15/2017 Had to redesign this "area" so tested it on the right side first . Happy for the most part , apparently 3M 77 spray adhesive is temperamental in colder work environments making some areas a pain . The 'boot' for the stick was "supposed" to be recessed but was unable to get the material to conform to the shape i wanted . so this is what i ended up with . 120mm case fans are going to be mounted in the front of each armrest aiming toward the sticks . The hope is after i add 3/16 eyelets around the boot it will blow air upwards on the sticks keeping hands from sweating . The pinned area of the pinky trigger rubs when articulating the stick forward but its 4 way vinyl so it "should" ( theres that damn word again ) not be a problem . lazy or greedy with my time just didnt feel like looking for a seamstress to make me one ... would rather fight it for 3 hrs and fail than just have someone do it for me . 04/18/2017 Alignment issues becouse the arms and base kickers are not landed atm . I can put the back and top together after i finished T-molding and trim . The holes are for the fans btw .