It is going to work fine so I am going to keep it. A while back the right throttle broke off at the slider. I glued and screwed a tiny metal strap to both the left and right throttle to permanently lock them together. Tonight, the left throttle snapped, and I do not want to spend money on a throttle right now. I was looking to see if I might glue or drive screw in to hold it together so I could continue to slide the throttle forward and back, but it just is not doable. Then I had an idea, since I was using the top thumb rotary dial as the mining laser throttle, and the lower thumb rotary dial as the speed controller I figured I could use one for the throttle and if so, just lock the throttle grip in place and use the rotary dial for the throttle. It checked out so I just duct taped the grips into place and played with all the rotary dials and settled on the throttle using the top thumb rotary, the mining laser with the bottom thumb rotary, and the speed controller with the rotary #4 dial. It isn't perfect, but it works. It also works fine in MSFS 2024. Later on, I am going to upgrade to a better throttle. Any recommendations?