I know there have been many questions about the Thrustmaster warthog setup, and there is a lot of good answers to many of the issues people face. However, my problem hopefully is that I'm just doing something stupid, because no one seems to have the same problem. I'll explain. I have a Thrustmaster warthog stick throttle and pedals. in the Windows 10 joystick settings the only thing showing are these three items. In Star Citizen, all three are seen and I can map them without issue. Everything works great! However if I launch the Target software, Star Citizen goes full derp and does not recognize the combo controller. * In the windows cpl the only device is the "thrustmaster combined" * In star citizen, I've cleared the bindings, loaded the "thrustmaster profile" loaded defaults, all I get are some random throttle inputs. I've loaded another users target profile, and I've created my own target profile. NOPE So in the target software I loaded a default warthog profile from thrustmaster, bound one switch on the throttle to "n" for landing gear, then spent two hours loading and clearing any in game bindings I could find. Flip the switch.... Nothing. I know the three devices are mapped into one device. I know the target software is mapped and running, and before launching SC I know all the devices are seen. The target software test shows all working. What do you have to do in SC to see/load the target device? And before anyone says just use the SC bindings, I have macros, and multi-function commands I bind to single switch actions. The SC binding don't allow for on-to-off and off-to-on state change bindings. Or multiple commands from one switch. E.g hold "F" --> zoom in --> Hud right. Or launching flare/chaff combos like Flare-->Chaff, or Flare 1-2-1 I hope someone with a Warthog running the Target software can help!