Hi Everyone, Could use a little help here. Hardware: Each device is going to a separate USB port on the computer and not through a hub and not daisy chained together. - Virpil MT-50 Throttle first addition - Virpil Control Panel 2 - VKB Gunfighter MCG - Tobi eye tracker - Keyboard and mouse TLDR: Through the virpil or VJOY/Gremlin software setup key binds in PTU or Live. Keybinds from the Control Panel are recognized in the SC settings menu but then when I am in Arena Commander or Universe the keybinds don’t recognize or work. The device (Control Panel) is working in DCS with no issues and I am not using VJOY/Gremlin for DCS. The MT-50 Throttle has no issues if it’s physical or virtual. I also checked out the i_DumpDeviceInformation from within SC and was to confirm that there: - Virpil method with no VJOY/Gremlin that there is 3 devices - VJOY/Gremlin method had 1 joystick and 1 Virtual Joystick - VJOY/Gremlin method with 2 virtual joysticks and no physical - Here is an example picture from the logs which obviously changed each time I adjusted the above. The part that is puzzling me is why are the devices being recognized as acceptable keybinds from different inputs but then not working in game. What I have tried: The two commands that I have been using for testing are Quantum operator mode and Landing gear. - VJOY with HideHide and joystick gremlin - Map both throttle and control panel to Joy single device with 64 buttons - Map buttons on Control Panel to keyboard command (n) and (b) - Using two Virtual Joysticks and no physical joysticks - Also added in a 0.1 second pause on both map to keyboard and for the joystick button remap - Uninstalling all HID controllers in device manger - Virpil 32 button split then retried without VJOY and With VJOY - Complete reg uninstall of start citrizen - Firmware update on all devices (remapped the PID and vendor iD back to the devices so they stayed the same) Let me know your thoughts and any idea’s I can try. Cheers, SkyeCapt